Filter
Top Products
Emerson Process Management GmbH & Co. OHG1-8
X-STREAM X2
Short Form Manual
HASX2E-SFM-HS
02/2012
1.4 X-STREAM X2GP: 19 Inch Table-Top or Rackmount Design
1.4 X-STREAM X2GP
This model can be fitted with up to four
measurement channels in any combination.
The physical components can optionally be
encased in a cover. This area can be held at
a specic temperature of up to 60 °C to mi-
nimize interference from changes in external
temperature.
Units congured for rack mounting can be
converted for tabletop use by removing the
lateral mounting brackets and attaching the
four feet supplied as accessories.
Connection to power supply
Main power is supplied via the IEC chassis
plug mounted on the rear panel, with inte-
grated power switch and fuse holders. The
internal wide range power supply unit enables
the analyzers to be used worldwide.
Interfaces
Electrical connections for interface signals are
provided via submin-D connectors mounted
on the rear panel of the device ( Fig. 1-3).
For applications where screw-type terminals
are preferred, optional adapters are available,
which are mounted directly onto the submin-D
connectors.
Up to two digital I/O cards may be installed.
Gas connections
Depending on the conguration of the unit
(number of measurement channels and serial
or parallel connection), sample and calibra-
tion gases are fed into the unit via up to 8
threaded connectors mounted on the rear
panel. The conguration of the connectors is
indicated on an adhesive label located near
the connectors.
A further optional tube tting enables the
housing to be purged
to minimize interference
from the ambient atmosphere,
or
when measu-
ring corrosive and/or ammable gases.