Filter
Top Products
SC Series Instruction Manual page 125
Relay Output Channel13
13.3 Setup Procedure
If you are not familiar with operating the instrument in the SETUP menu mode,
see “SETUP Menu mode” on page 23. A listing of all menu item is given in “Setup
Menu Reference” on page 157.
Step 1: Wire to the channel’s connector.
See the “Wiring” section earlier in this chapter for details.
Step 2: Use the appropriate Limit Menu to setup the limits.
See “Limits” on page 53 for information about limits.
NOTICE
A SensoCode program running on a Mathematics Virtual Channel may over-
ride the default behavior of the relay outputs. Consult the Customer Information
Sheet included with your instrument for details.