Honeywell SC1000 Stud Sensor User Manual


 
page 130 008-0608-00
14.2 Wiring
Connect your readout instrument to a DAC Output channel by wiring it to the 12-pin
connector of that channel. The Customer Information Sheet that shipped with the
instrument describes which cards are installed in each channel. The pin-out for this
connector is shown on the following table.
The Analog Output and Analog Return pins are electrically isolated from all other pins
on the instrument.
Table 3-9: DAC Output Channel Pin Connections
Pin Label Function Reference Pin
1 (top) N/C No connection
2 N/C No connection
3 N/C No connection
4 N/C No connection
5 N/C No connection
6 N/C No connection
7 +OUT Analog Output 8
8 -OUT Analog Return -
9 N/C No connection
10 N/C No connection
11 N/C No connection
12
(bottom)
N/C No connection