Filter
Top Products
63
Chapter 4 - Performing Cutting Using a Computer
4-3. Installation and Overview of the Included Software
Installation and Setup
Installation and Setup
1
Switch on the computer and start Windows.
If you are installing under Windows NT 4.0/
2000/XP, log on to Windows as a member of
the "Administrators" or "Power Users" group.
2
Place the CD from the Roland Software Pack-
age in the CD-ROM drive.
The Setup menu appears automatically.
3
Click the in [Click here], then choose [EGX-
600] or [EGX-400]. Click [Install].
If there are programs you don't want to install, then clear
their check boxes before you click [Install].
4
The Setup program starts. Follow the messages
to carry out setup and finish setting up the pro-
gram.
When the setup for one program finishes, the setup for
the next program starts. In the interval until the next setup
starts, a dialog box showing the progress of processing
is displayed.
5
If the following screen appears while installing
the driver, click the drop-down arrow and
choose the port for the cable connected to the
computer.
When using a serial cable : [COM1:] or [COM2:]
When using a printer cable : [LPT1:]
6
The driver settings appear. When you make the
settings for the communication parameters of
this machine, make the parameters match the
values displayed here.
Click [Close] to finish installing the driver.
(Continued on the next page)
EGX-600
EGX-600 Driver Install
Settings:[EGX-600]