Filter
Top Products
90
Chapter 5 - The Teaching Feature
5-7. List of Commands
6 CUT-ZM
Function
This moves the spindle head to the specified X, Y, and Z coordinates (at the specified feed rate and via the R level).
Value ❶ Z-axis feed rate (0 to 50 mm/s)
Value ❷ X, Y, and Z coordinates for the movement destination
This moves the spindle. The operation is as follows.
1. Move at the highest speed to the upper limit of the Z axis.
2. Move at the highest speed to the X and Y coordinates specified here.
3. Move the Z axis at the highest speed to the height specified for [R LEVEL] at the [SETTING] submenu.
4. Move at the specified speed to the Z coordinate specified here.
This command has no function for rotating or stopping the spindle.
◆ Basic Screen
Specify the Z-axis feed rate to use when moving from the R level to the specified Z-axis coordinate. Specifying [0] sets a
speed of 0.5 mm/s. After you input the speed, press the [ENTER/PAUSE] button to go to the settings at Detail Screen 1.
◆ Detail Screen 1
Specify the X, Y, and Z coordinates for the movement destination. At this screen you can use button operations to move
or rotate the spindle. You can decide on the movement destination as you verify the on-screen coordinate values and the
actual position. To set the present location of the spindle as the movement destination, press the [ENTER/PAUSE]
button. To cancel and return, press the [MENU] button.
◆ Detail Screen 2
This displays the X, Y, and Z coordinates of the set movement destination. Use this screen to verify the settings.
1:
6 CUT-ZM 50
◆ Basic Screen
to cancel
❶
X 1000 Y 1000
Z -500 8000RPM
X 1000 Y 1000
Z -500 Dest.
◆ Detail Screen 1
◆ Detail Screen 2
❷
❷
❷