Filter
Top Products
SUMMARY OF WELDING
PROCESSES AND MACHINE
SETTINGS
Table B.3 summarizes the requirements for various
welding processes you can perform with the
RANGER 9.
OPERATION
B-13 B-13
RANGER 9 RANGER 9
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TABLE B.3 - SUMMARY OF WELDING PROCESSES
Process Control Idle Output Welding Electrode To Start Welding
Cable Mode Control Terminals State When
Used Switch Switch Not Welding
Stick – CC No Auto At Welder Always on Hot Touch electrode to work.
Welding starts immedi-
ately and engine goes to
high idle.
TIG - CC Yes Auto Remote Remote Cold Press Amptrol. Welding
K930-1/K936-1 starts immediately.
(With Amptrol)
Wire Feed - CV, Yes Auto Remote Remote Cold Press gun trigger,
LN-25 with 42V RANGER 9 contactor
Remote Control Kit closes. Welding starts
immediately and engine
goes to high idle.
Wire Feed - CV No Auto At Welder Always on Cold Press gun trigger, LN-25
LN-25 with internal contactor closes. Weld-
contactor ing starts immediately
and engine goes to high
idle.
Wire Feed - CV Yes Auto Remote Remote Cold Press gun trigger,
LN-742 RANGER 9 contactor
closes. Welding starts
immediately and engine
goes to high idle.
Wire Feed - CV, Yes High Remote Remote Cold Press gun trigger,
LN-7 RANGER 9 contactor
closes. Welding starts
immediately.