Filter
Top Products
5 - 15
MDS-D-SVJ3/SPJ3 Series Specifications Manual
5-2 Spindle options
5-2 Spindle options
According to the spindle control to be adopted, select the spindle side detector based on the following table.
(a) No-variable speed control
(When spindle and motor are directly coupled or coupled with a 1:1 gear ratio)
(Note 1) ● :Control possible
x :Control not possible
(Note 2) When spindle and motor are coupled with a 1:1 gear ratio, use of a spindle side detector is
recommended to assure the precision.
(b) Variable speed control
(When using V-belt, or when spindle and motor are connected with a gear ratio other than 1:1)
(Note 1) ● :Control possible
x :Control not possible
(Note 2) Control not possible when connected with the V-belt.
(Note 3) Control not possible when connected with other than the gears.
(c) Cautions for connecting the spindle end with an OSE-1024 detector
[1] Confirm that the gear ratio (pulley ratio) of the spindle end to the detector is 1:1.
[2] Use a timing belt when connecting by a belt.
Spindle
control item
Control specifications Without spindle side detector With spindle side detector
Spindle control
Normal cutting control ●
This normally is not used for no-
variable speed control.
Constant surface speed control (lathe) ●
Thread cutting (lathe) ●
Orientation control
1-point orientation control ●
Multi-point orientation control ●
Orientation indexing ●
Synchronous tap
control
Standard synchronous tap ●
Synchronous tap after zero point return ●
Spindle synchro-
nous control
Without phase alignment function ●
With phase alignment function ●
C-axis control C-axis control ● (Note 2)
●
Spindle
control item
Control specifications
Without spindle side
detector
With spindle side detector
TS5690/ERM280/
MPCI Series
OSE-1024
Proximity
switch
Spindle
control
Normal cutting control ●●●-
Constant surface speed
control (lathe)
● (Note 2) ●●x
Thread cutting (lathe) x ●●x
Orientation
control
1-point orientation control x ●●●
Multi-point orientation
control
x ●●x
Orientation indexing x ●●x
Synchronous
tap control
Standard synchronous
tap
● (Note 3) ●●x
Synchronous tap after
zero point return
x ●●x
Spindle syn-
chronous
control
Without phase alignment
function
● (Note 2) ●●x
With phase alignment
function
x ●●x
C-axis control C-axis control x ● xx