Filter
Top Products
Appendix 7 - 6
Appendix 7 Compliance with Restrictions in China
MITSUBISHI CNC
Appendix 7-1-5 Mitsubishi NC product subject to/not subject to CCC certification
The state whether or not Mitsubishi NC products are subject to the CCC Certification is indicated below, based
on the "First Catalogue of Products subject to Compulsory Product Certification" issued by the State General
Administration of Quality Supervision, Inspection and Quarantine (AQSIQ) of the People's Republic of China and
the Certification and Accreditation Administration of the People's Republic of China (CNCA) on July 1, 2002.
(Note 1) The China HS Code is determined by the customs officer when importing to China. The above HS
Codes are set based on the HS Codes used normally when exporting from Japan.
(Note 2) Reference IEC Standards are used as the actual IEC Standards may not match the GB Standards
in part depending on the model.
Whether or not the NC products are subject to CCC Certification was judged based on the following five
items.
(a) Announcement 33 (Issued by AQSIQ and CNCA in December 2001)
(b) HS Codes for the products subject to CCC Certification (Export Customs Codes)
* HS Codes are supplementary materials used to determine the applicable range. The applicable range
may not be determined only by these HS Codes.
(c) GB Standards (This is based on the IEC Conformity, so check the IEC. Note that some parts are
deviated.)
(d) Enforcement regulations, and products specified in applicable range of applicable standards within
(e) "Products Excluded from Compulsory Certification Catalogue" (Issued by CNCA, November 2003)
Reference
• Outline of China's New Certification System (CCC Mark for Electric Products), Japan Electrical
Manufacturers' Association
• Outline of China's New Certification System (CCC Mark for Electric Products) and Electric Control
Equipment, Nippon Electric Control Equipment Industries Association
Model China HS Code (Note 1)
Judgment on whether or not subject to
CCC Certification
Power supply unit
Servo/spindle drive unit
85044090
85371010
Not subject to CCC Certification
Servo/spindle
85015100
85015200
Not subject to CCC Certification
NC - Not subject to CCC Certification
Display unit - Not subject to CCC Certification