Filter
Top Products
RangeMax Wireless-N DSL Gigabit Modem Router DGN3500 User Manual
5-4 Advanced Configuration
v1.0, November 2009
The LAN Setup screen allows configuration of LAN IP services such as Dynamic Host
Configuration Protocol (DHCP) and Routing Information Protocol (RIP).
The modem router is shipped preconfigured to use private IP addresses on the LAN side and to act
as a DHCP server. The modem router’s default LAN IP configuration is:
• LAN IP address: 192.168.0.1
• Subnet mask: 255.255.255.0
These addresses are part of the designated private address range for use in private networks and
should be suitable for most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in the LAN Setup screen.
To configure LAN settings, log in to the modem router, and under the Advanced heading, select
LAN Setup. The following screen displays:
If you make changes you must click Apply in order for the changes to take effect.
Figure 5-2
Note: If you change the LAN IP address of the modem router while connected through
your Internet browser, you will be disconnected. You must then open a new
connection to the new IP address and log in again.