Filter
Top Products
6-1
DMS-MTX DualMode Metrocell Cell Site Description
6
Datafilling a Metro Cell Site
Datafill Overview
This section outlines the differences which you should consider when
datafilling a Metro site. It makes no attempt at dealing with the entire datafill
procedure and assumes that you are familiar with the MTX Cell Site Datafill
Procedures. Please refer to
NTP 411-2131-461 ICP Datafill Guide
for
information concerning the entire Cell Site Table Datafill.
A Metro Cell site looks for all intensive purposes like any other ICP/ICRM
cell site to the MTX. It uses all the same tables, loads, and parameters as do
the previous ICP/ICRM methods. The outstanding difference, which is
apparent, is that more Trunks and DSPMs will be required to service the
additional radios that the Metro RF frame is equipped with. The following
datafill tables will be addressed in the view of differences to keep in mind
when datafilling a Metro Cell Site:
Table 6-1
Datafill differences of the Metrocell from an NT800DR cell
Table Metro differences
CLLI More trunks should be assigned as each RF frame can be
equipped with 8 more radios than a standard macrocell frame.
ACUALM PA Fan Alarms are laid out differently with the new RF frame.
CCHINV The RF frame location of the DRU should be correctly identified
in relation to the ICRM P-side card port number.
LCRINV The RF frame location of the DRU should be correctly identified
in relation to the ICRM P-side card port number.
VCHINV The RF frame location of the DRU should be correctly identified
in relation to the ICRM P-side card port number.