Filter
Top Products
Section VIII - Power$ync II
™
Operation
Quincy Compressor
®
- QSD™ 45
controller will turn the machine off. If
SHUTDOWN is pressed accidentally and the unit
is in the process of shutting down but has not yet
stopped, the programmed shutdown can be
aborted by pressing SHUTDOWN again.
Compressor Settings and Maintenance Displays
The initial Start-up Display (page 43) offers the user the
choice to press START (to begin compressor operation)
or ENTER (to move to the compressor setup and
maintenance menu). Once compressor operation begins,
the operator will see one of the Operational Displays
(pages 43-44). If ENTER is pressed, the operator will be
directed into a variety of setup and maintenance displays
which allow changes to operating pressures, mode of
operation, date and time, or to check and/or reset
maintenance hourmeters. These setup and maintenance
options can be accessed at any time during normal
compressor operation by pressing ENTER when the
controller has an Operational Display showing.
The Setup Menu portion of the Power$ync II
™
control
displays can be divided into several groups; Pressure
Settings, Mode of Operation, Maintenance Hourmeters,
Modem Communications, Clock and Control Testing.
IMPORTANT
a) If a situation occurs requiring a WARNING
message to be displayed, that message will
interrupt any active display.
b) ENTER will always accept the displayed data and
either move forward to the next display or
backward to the previous display, depending on
the requirements of the display.
c) If the display does not make reference to ENTER,
pressing ENTER will take the operator back to
the previous display.
From the initial Start-up Display or any of the
Operational Displays, pressing ENTER will call the first
Setup Menu.
Mode and Pressure Displays
COMPRESSOR SETUP MENU
MODE AND PRESSURE MENU ➔ PRESS F1
MAINTENANCE MENU ➔ PRESS F2
PRESS ENTER TO RETURN
Press F1 to access the Mode and Pressure Menu
to select Auto Dual, Continuous Run or Network
Mode. Press F2 to move into the Maintenance
Menu where hourmeters can be checked and set,
time and date can be changed and Power$ync II
™
valve operation can be checked. Press ENTER to
return to the previous display.
F1allows the mode of operation to be selected or
changed. For an explanation of the modes of operation
refer to pages 32-33.
COMPRESSOR MODE OF OPERATION
AUTO DUAL TIMED STOP ➔ PRESS F1
CONTINUOUS RUN ➔ PRESS F2
NETWORK SCHEDULED ROTATION ➔ PRESS F3
Press F1 to access the Auto Dual Configuration
Menu. Press F2 to access theContinuous Run
Configuration Menu. F3 accesses the Network
Configuration Menu. Although it is not displayed
in this menu, ENTER can be pressed to return to
the previous Setup Menu. Pressing any F key will
result in the compressor switching modes of
operation as soon as ENTER is pressed.
AUTO DUAL CONFIGURATION
SET LOAD/UNLOAD PRESSURES ➔ PRESS F1
SET SHUTDOWN TIMER ➔ PRESS F2
The Auto Dual Configuration Menu allows the
operator to set various operating parameters for
a compressor running in this mode. The
compressor comes from the factory with preset
parameters based on the information provided on
the order. These should only be changed if system
conditions are different from those present at the
time the order was placed.