Filter
Top Products
Section VIII - Power$ync II
™
Operation
50 Quincy Compressor
®
- QSD™
If the network is powered-up, but not running, or if there
are only two machines on the network, the following
message may be too quick to be seen.
PLEASE WAIT
TRANSFERRING NETWORK DATA TO
ALL ON-LINE COMPRESSORS
Press F2 to edit the networked pressure deadbands:
1>000U 000L 2>000U 000L 3>000U 000L
4>000U 000L 5>000U 000L 6>000U 000L
UP/DOWN DEADBAND, F1 EDIT, ENTER RETURN
When this screen is displayed, the unload and load
pressure settings will be flashing for position
number one. To edit position number one, press
F1. The unload pressure setting will start flashing
slowly, indicating that this number is ready to edit.
Use the UP and DOWN arrow keys to change the
setting. Once the correct setting has been
specified, press ENTER to accept. The load
pressure setting will now begin to flash slowly.
Follow the same procedure to change the load
pressure setting. When the unload and load
pressure settings have been accepted, the control
will flash both settings, indicating that you can
now move to another position setting. To move to
the second position, use the UP arrow key.
Following the same procedure, adjust the unload
and load pressures for all machines on the
network. Press ENTER to transfer this data to all
on-line compressors and return to Network
Configuration Menu 3.
Press the UP arrow key to move to Network
Configuration Menu 4. From this display, sequences and
schedules can be cleared from all on-line networked
compressors at one time, from one machine.
NETWORK CONFIGURATION MENU 4
CLEAR SEQUENCE ➔ PRESS F1
CLEAR SEQUENCE AND SCHEDULE ➔ PRESS F2
UP FOR NEXT MENU/DOWN FOR PREVIOUS MENU
To clear a particular sequence from the memory,
press F1.
When F1 is pressed, the following display will appear:
NETWORK SEQUENCE ERASE
SEQUENCE NUMBER TO CLEAR ➔ 1
PRESS ENTER TO ACCEPT VALUE
Use the UP or DOWN arrow keys to scroll to the
proper sequence number to clear. Once the proper
sequence number is displayed, press ENTER.
The control will display a warning message to prevent the
accidental erasure of a particular sequence. This warning
message gives the option of continuing the process of
erasing a sequence or aborting the process.
NOTICE
YOU HAVE SELECTED SEQUENCE 1 TO CLEAR
NOTICE
PRESS F1 TO CLEAR OR ENTER TO ABORT
Press either F1 or ENTER to complete the process
and return the display to Network Configuration
Menu 4.
To clear all sequence and schedule information from all
compressors on the network, press F2.
NOTICE
YOU WILL CLEAR ALL SEQUENCE AND SCHEDULE
NOTICE
PRESS F1 TO CLEAR OR ENTER TO ABORT
Press either key to complete the process and return
to Network Configuration Menu 4.
From Network Configuration Menu 4, press the UP
arrow key to move to Network Configuration Menu 5.
NETWORK CONFIGURATION MENU 5
POINTER PASSING DELAY TIME (SECONDS) ___
ENTER ACCEPTS VALUE / EXITS MENU
Press the UP or DOWN key to increase or decrease
this value. Press ENTER to return to the previous
display.