Filter
Top Products
13
GM 3000AC
OPERATING MANUAL
EDITION 05/2007
PART NO. DOC364831
4 DESCRIPTION
4.1 AREA OF APPLICATION, USING IN ACCORDANCE WITH THE INSTRUCTIONS
The gun is suitable for atomising liquid materials, particularly coating materials, using the
AirCoat process.
4.1.1 PROCESSABLE MATERIALS
Top-coat paints, primer paints, corrosion protection solvents, textured paints, lyes, staining
solvents, clear paints, parting solvents, etc. on a solvent or water basis
.
Note:
In the event of application problems, contact your WAGNER branch and the paint manu-
facturer.
4.2 SCOPE OF SUPPLY
The AirCoat gun is available in different variants as shown below. In accessories different
fl at nozzles and round jet nozzles are available. The nozzle size depends on the paint and
on the application. Therefore the nozzle is not included in the scope of supply. For a nozzle
list and other accessories look in chapter 9.
4.2.1 HV-VARIANTS
These guns have a blue air cap. This air cap is specially designed for high viscosity (HV)
material.
Qty Part-No. AirCoat gun
1 0364001 GM 3000AC with fi lter + M16x1.5“ material connector HV
1 0364002 GM 3000AC with fi lter + NPSM1/4“ material connectors HV
1 0364030 GM 3000AC with fi lter + NPSM1/4“ material connector HV USA
1 0364003 GM 3000AC without fi lter + M16x1.5“ material connector HV
1 0364004 GM 3000AC without fi lter + NPSM1/4“ material connector HV
1 0364031 GM 3000AC with fi lter + NPSM1/4“ material connector HV USA
SIHI_0019_GB
WARNING
Hot coating substances!
Burns
Wear antistatic protective gloves.
When operating the unit with a coating material with a temper-
ature greaterthan 43°C;109.4°F:Identify the unitwith a warning
sticker "Warning - hot surface".