Filter
Top Products
28
GM 3000AC
"?
X
B_00039
A
B
C
D
OPERATING MANUAL
EDITION 05/2007
PART NO. DOC364831
5.4.4 CLEANING AIRCOAT NOZZLES
For disassembly and assembly see AirCoat nozzles section 5.4.3.
The AirCoat nozzle (C) can be placed into a cleaning solvent which has been recommend-
ed by the paint manufacturer.
5.4.5 UNBLOCKING CLOGGED NOZZLE
1. Relieve the pressure from the gun and unit.
2. Secure gun with trigger safety catch.
3. Unscrew aircap nut with nozzle guard (A).
4. Remove aircap (B).
5. Pull out the clogged nozzle (C) from the air cap (B), reverse it and replace it into nozzle seal
(D).
6. Place air cap (B) on the nozzle (C). Take care that the nozzle fi tted is correctly
(see fl ats X)
7. Fit the aircap nut with nozzle guard (A) over the air cap (B) onto the spray gun and
tighten by hand.
8. Switch the material pressure back on.
9. Turn the safety catch to the spraying position and briefl y pull trigger.
10. When the blockage has been fl ushed out secure the gun with safety catch.
11. Relieve the pressure from the gun and unit.
12. Unscrew aircap nut with nozzle guard (A).
13. Remove air cap (B) and reverse nozzle (C) again.
14. Refi t air cap (B) on the nozzle (C). Take care that the nozzle fi tted is correctly (see fl at
side X)
15. Fit the aircap nut with nozzle guard (A) over the air cap (B) onto the spray gun and
tighten by hand.
16. Switch the material pressure and the air pressure back on.
Nozzle in „spray“ position
Nozzle in „cleaning“ position