Filter
Top Products
45
GM 3000AC
5
1
6
2
3
4
B_01296
9
8
10
10
1.0 Nm
±0.5 Nm
;
0.74 lbft
±0.36lbft
max. 1.5 mm
0.06 inch max.
B_01295
X
1
2
OPERATING MANUAL
EDITION 05/2007
PART NO. DOC364831
Assembly
1. Lightly grease o-ring (3) using castor oil and push it onto gasket
(4). Insert the gasket assy. into connection piece.
Note
By assembling do not damage gasket (4)
2. Screw adjuster screw (2) into connection piece using Loctite
270.
Note
Do not thighten fully the adjuster screw.
3. Tighten the adjuster screw (2) using a torque wrench to a
torque of 1.5 Nm
±0.5 Nm
; 1.11 lbft
±0.37 lbft
4. Put the assembled part for 30 minutes at 40°C; 104°F in a oven.
Note
The part must be placed in the oven on the fi lter housing (1).
5. Press nipple (5) into fi lter housing (1). Place the edge fi lter (6)
into connection piece. Screw the fi lter housing (1) and pivot
joint together. (Lightly grease the thread with vaseline)
6. Check the pivot joint for leaks using solvent or spray oil and a
max. pressure of 25 MPa; 250 bar; 3626 psi or 16 MPa; 160 bar;
2320 psi.
Dimensional accuracy:
If the distance „x“ between pinhead (1) and distance piece (2) is larger than 1.5 mm; 0.06
inches, the pivot joint must be replaced.