Filter
Top Products
35
GM 3000AC
"?
B
C
D
A
B_00033
E
F
OPERATING MANUAL
EDITION 05/2007
PART NO. DOC364831
7. Pull the valve rod (D) out again.
8. Screw in the packing screw (G) and do not tighten fully.
9. Put trigger (I) in position, and insert trigger pin (H) and screw ( J).
10. Place the valve tappet (E) over the valve rod (D). Push both parts from behind into the
housing.
11. Place the springs (C) and (B) in place and tighten tension cap (A).to a torque of 8 Nm;
5.9 lbft.
12. Tighten seal package (F) with packing screw (G) carefully. Take care of a smooth
movement of trigger.
13. Start-up see chapter 5.3.
Note:
Ensure that the springs plates in the sealing package (F)
are in the correct position.
6.5 REPLACING NOZZLE SEAL
1. Take out of operation and clean.
2. Relieve the pressure from the gun and unit.
3. Secure gun with trigger safety catch.
4. Unscrew aircap nut with nozzle guard (A)
5. Remove air cap (B) and nozzle (C).
6. Prise the tip seal (D) out using a small screwdriver.
7. Push the new nozzle seal into the valve seat holder (E).
8. Re-assemble aircap in reverse order
CAUTION
Forming air and atomizer air not separate !
Poor spray pattern
Spray jet cannot be adjusted
Treat the distributor seal (F) with care.
SIHI_0030_GB