Filter
Top Products
41
GM 3000AC
OPERATING MANUAL
EDITION 05/2007
PART NO. DOC364831
Repair spare parts
Item K Qty Part-No. Description
1 1 0364927 Gun housing pre-assembled fi lter
1 1 0364928 Gun housing pre-assy. M16x1.5
1 1 0364929 Gun housing pre-assy. NPSM1/4“
1 1 0364934 Gun housing AC-H M16x1.5
2 1 0364339 Seal material inlet
3 1 9922720 Snap ring
4 1 0364336 Banjo bolt
5 1 0364343 Filter housing bended
6 1 9992833 Loctite 638 green
7 1 0364340 Seal fi lter
8 1 0364353 Material outlet fi tting M16x1.5
8 1 0364355 Material outlet fi tting NPSM1/4“
9 1 9992528 Loctite 270
Assembly
1. Push the new banjo bolt (4) onto fi lter housing (5) or onto material outlet nipple (8).
2. Place the snap ring (3) in the groove of fi lter housing (5) and place the seal material (2)
onto fi lter housing (5).
3. Apply loctite 638 to the thread of the bajo bolt (4) and of the fi lter pipe (5).
4. Push complete fi lter housing or material outlet fi tting onto gun housing and ensure
that it is in the correct position. Tighten the banjo bolt (4) using a torque wrench to a
torque of 15 Nm; 11 lbft.
5. Put the cemented joint for 30 minutes at 40°C; 104°F in a oven.
6. Assemble the spraygun and check the gun for leaks using solvent or spray oil and a
max. pressure of 25 MPa; 250 bar; 3626 psi or 16 MPa; 160 bar; 2320 psi.
7. Check the gun for leaks using solvent or spray oil and a max. pressure of 25 MPa; 250
bar; 3626 psi or 16 MPa; 160 bar; 2320 psi