Revision 1.4.16a Page 107
6.12.5.2.12 Flow Label
Program this parameter with a text string which identifies the particular fluid flow parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
6.12.5.2.13 Volume Instance
Program this parameter to match the desired instance number of the volume reading for this channel.
You can program this parameter to any value between 0 and 252. The default value for this
parameter is 0.
6.12.5.2.14 Volume Label
Program this parameter with a text string which identifies the particular volume parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
6.13 Maretron FPM100 Configuration
The DSM250 is capable of configuring the Maretron FPM100 Fluid Pressure Monitor. This describes
the configuration of the Maretron FPM100 firmware version 1.0.1.
Figure 98 – FPM100 Configuration Screen
6.13.1 Advanced Configuration…
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
