Revision 1.4.16a Page 73
Figure 62 – DSM200 Remote Configuration Screen
6.7.1 Remote Device Selection
A DSM250 unit can be used to configure a remote DSM200 to set which NMEA 2000
®
devices are
selected for display on the remote DSM200 unit. In this manner, multiple devices of the same type
may be used on a NMEA 2000
®
network in a fail-safe configuration. For example, a certain compass
unit out of several may be selected for display on the remote DSM200. The “Remote Device
Selection…” menu for an example network configuration can be seen in Figure 63 below.
WARNING: Do not select multiple devices of the same type for display. This will result in multiple and
possibly conflicting readings.
Figure 63 – DSM200 Remote Device Selection Screen
The “NA” column of the menu displays the node address the device is using.
The “Manuf.” column of the menu displays the manufacturer of the device.
The “Model” column displays the model number of the device.
The “SN#” column displays the serial number of the device, so that any of two or more devices of
the same manufacturer and model number may be distinguished from one another.
