Revision 1.4.16a Page 145
Figure 152 – RAA100: Setting the Rudder Number
6.19.5 Operating Mode
The RAA100 can be operated in one of two operating modes, depending on the installation.
• NMEA 2000 (the only thing that is connected to the resistive sender is the RAA100)
• NMEA 2000 & Analog Gauge (in addition to the RAA100, the resistive sender is also
connected to a dual-coil analog gauge).
It is important that this setting be performed correctly in order for the RAA100 to produce correct
angle measurements. A screenshot showing configuration of the operating mode appears in Figure
153 below. To configure the operating mode, use the Scroll Up ( ) or Scroll Down ( ) keys to
move the highlighted cursor over the “Operating Mode:” menu item, then press the Enter key ( ) to
move the highlight over the operating mode value. Use the Scroll Up ( ) or Scroll Down ( ) keys
to change the operating mode to the desired value, and finally, press the Entry key to confirm your
selection and store the operating mode within the RAA100.
Figure 153 – RAA100: Setting the Operating Mode
