DSM250 User’s Manual
Page 4 Revision 1.4.16a
3. Remove the template from the mounting surface.
4. Insert the 2” studs into the back of the DSM250.
a. Make sure the studs are fully inserted into the back of the DSM250 but don’t over tighten
the studs.
b. Do not use threadlocking compounds containing methacrylate ester, such as Loctite Red
(271), as they will cause stress cracking of the plastic enclosure.
5. Remove the back of the case from the DSM250.
a. Place your thumbs on top of the studs and your finger along the side of the case and
squeeze the back cover off the DSM250.
6. Insert the back of the DSM250 through the front side of the cutout.
7. Place the back cover on the opposite side of the mounting surface with the mounting holes
aligned with the mounting studs and secure with the supplied hardware.
a. Place the flat washer on the stud first followed by the lock washer followed by the knurled
nut.
b. Hand tighten the knurled nut.
Figure 2 – Flush Mounting the DSM250
2.3.3 Gimbal Mounting the DSM250
The DSM250 can be gimbal mounted to any horizontal surface such a counter or ceiling as shown in
Figure 3. The optional gimbal mounting assembly (part number DSMMNTASSBLY) includes a
bracket and screws for attaching the bracket to the DSM250, a stand, and 2 knobs for fastening the
DSM250/bracket to the stand.
