Revision 1.4.16a Page 51
Figure 37 – Setting the Transducer Depth Offset in an Airmar Depth Transducer
With the offset value highlighted, you can change the offset by using the Increase and Decrease
keys ( or ). Once you have selected the desired offset, push the Enter key ( ) to complete
the transducer depth offset calibration. This procedure actually programs the offset value into the
transducer such that all displays subsequently receive the offset information. This means you don’t
have to program multiple displays each with the corresponding offset information as the information is
stored at a single place (at the source).
6.1.10 Trip Log
The DSM250 is capable of clearing the trip log counter within an Airmar speed transducer. You zero
the trip log by pressing the Enter key ( ) with the “Trip Log:” menu item selected which results in
the screen shown Figure 79. Pressing the Accept ( ) key while the “Reset” menu item is selected
will complete the operation. Resetting the trip log zeroes the transducer’s trip log such that all
displays receive a zeroed value.
Figure 38 – Resetting the Airmar Speed Sensor Trip Distance Log
