A SERVICE OF

logo

Revision 1.4.16a Page 165
®®
6.23 Maretron TLA100 Configuration
Maretron TLA100 tank level adapters on the network may be configured using the DSM250. This
describes the configuration of the Maretron TLA100 firmware version 1.6.14. The TLA100
configuration menu is shown in Figure 181 below.
Figure 181 – TLA100 Configuration Screen
6.23.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 182 – TLA100 Advanced Configuration Screen
6.23.1.1 Device Instance
This entry allo
ws you to program the NMEA 2000 device instance for the unit. You usually will not
need to modify the default value of “0” unless you have multiple units on the network.