Revision 1.4.16a Page 231
8.3.10 Remote Annunciators
Selecting the Remote Annunciators option will bring up a list of 16 ALM100 devices. If the
Annunciator is active on the NMEA2000
®
bus, and the Annunciator has been given a label, the label
will be displayed, in parenthesis, alongside the instance number.
Note: the DSM250 is limited to working with annunciators with data instance numbers in the range 0-
15.
Figure 271 – Remote Annunciator Enable/Disable
To enable a specific Annunciator, use the Scroll Up and Scroll Down buttons to position the cursor,
and then press the Enter button to move to the Tone column.
The options here are
• Enable
• Disable
The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the
Enter button again. The tone of the Annunciator will be the same as that set in 8.3.9.
8.3.11 Operating Mode Moored
See section 4.3.4 for a description of Operating Modes. For this Alert to be triggered when the vessel
is in the Moored state, this option must be set to Enabled.
The options here are
• Enable
• Disable
The desired option is selected using the Scroll Up and Scroll Down buttons, and then pressing the
Enter button again.
8.3.12 Operating Mode Underway
See section 4.3.4 for a description of Operating Modes. For this Alert to be triggered when the vessel
is in the Underway state, this option must be set to Enabled. The options here are
