A SERVICE OF

logo

DSM250 User’s Manual
Page 82 Revision 1.4.16a
6.9 Maretron DST100 Configuration
The DSM250 is capable of configuring Maretron’s DST100 for several different parameters including
trip log resetting, transducer depth offset, and speed calibration. This describes the configuration of
the Maretron DST100 firmware version 1.0.1.
Figure 75 – DST100 Configuration Screen
6.9.1 Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
Figure 76 – DST100 Advanced Configuration Screen
6.9.1.1 Device Instance
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will not
need to modify the default value of “0” unless you have multiple units on the network.