A SERVICE OF

logo

DSM250 User’s Manual
Page 194 Revision 1.4.16a
miles/hour. If the apparent wind speed is lower than this, then an error message will appear, which is
shown in Figure 226 below, and the calibration process will be aborted.
Figure 226 – WSO100 Configuration Aborted Due to Low Wind Speed
If the wind speed is sufficient, then a confirmation screen, shown in Figure 227 below, will appear,
indicating that a successful installation offset calibration has completed.
Figure 227 – Installation Offset Success Confirmation Screen
You may instead abort calibration by pressing the Abort Key ( ). If you do this, the installation
offset calibration process will be aborted and a message will appear noting that this has happened,
which appears in Figure 228 below.