Revision 1.4.16a Page 79
Figure 70 – Favorite Settings Transfer Completion Screen
6.8.6 Copy DST100 calibrations from local display
DST100 calibration data is not stored in the DST100 device. Rather each DSM150/DSM250 needs to
apply its own set of calibration parameters to the raw data received. This operation allows one
DSM250 to copy its calibration table to a second DSM250/DSM250.
Figure 71 – DSM150/DSM250 Copy DST100 calibrations from local display
6.8.7 Copy all settings from local display
This is the single operation that makes it easy to have multiple DSM150/DSM250 displays on a boat.
Set one DSM150/DSM250 up so that all its settings are correct, and quickly transfer all the alarms,
device settings and display setting to another DSM150/DSM250. Then go in and update the following
information to customize the new device.
• Display Settings Æ Advanced Configuration Æ Installation Descriptions
• Display Settings Æ Label
Also use this function to copy settings from an old DSM150/DSM250 to a new DSM150/DSM250
when replacing the device.
