Filter
Top Products
TO IN_rALL BEVEL HANDLE ASSEMBLY
See F-t_re 12.
• Liftthe end rap offthe bevel handle assembly usinga
fiat b|ade screwdriver,
• Holdthe nylonnut securelyand turnthe screw counter-
clockwise toremove thenutcompletely.
NOTE: Do not remove the screwfrom the handleor the
washer fromthe end ofthe screw.
• Placethe nylonnut intothe recessed holeon the back
ofthe height adjustinghandwheeland hold in place,
• Slidethe handle,screw, and washer intothehole onthe
he(ghtadjustln9l_n_'_heaL
• Usinga fiatheadscrewdriver, turn thescrewclockwise
and tighteninplace.
• Pushthe end cap back inplace on the end of the
handle.
HEXNUT
HEIGHT/BEVEL
ADJUSTINGRANDWHEEL
WONTRAIL
cLAMP
FRONTPAIL
SQUARERAIL
HOLDERNUT
Fig. 1"3
BEVEL
HANDLE
WASHER
TO INSTALL FRONT AND BACK RAILS
See Figures13 - 14,
• Loosenthe frontrailciarnps one halfturnfi'omthe
tightenedposition.Loosenthesquare ragholdernut
one-fourth(1/4)turn"_oallowthe front ra_to slide ovsr
it.
• Mount the _ontrailwith thescale faoincj theoutside
towardthe operator.
• Check to make sure the railclamps willsecurelyclamp
the rai(beforeslidingthe entireassembly intoposition.
If not, tighten the squarerailholdernutone-fourth(1/4)
turnand recheck.
• Slidethe railintoposition over both clampsand
secure.
• Mountthe rearrail,following the same ciamping
procedureas shownfor the front rail
SQUARERAIL
HOLDERNUT
REARRAIL
CLAMP
Fig. 14
18