TO ADJUST THE MITER BASE
See Figure33.
Remember: Check all settingsbeforelooseningscrews
for the foflowfng procedures.Once screwshave bean
toosened, these settingsmust be reset.
Eight screws ere visible on the miter base (B).
• Four screws (k")o_eon the holderplates and secure
these platesto therails. It isnot necessaryto loosenor
adjustthese screwsforthis adjustment procedure.
• Anotherpairof screws (L)isin thebase, at the rear.
Loosen thesetwo screws(I-)end the rear miter (ocking
o[amps (M).
• The lastpaZrof screwsis located on the infesdside of
the base. Loosenthe leftscrew(N) only,
• The right screw (O)will be usedas a pivotpoint.
NOTE: The fTonttWOmiter locking c(amps(P)and rail
clarnps shouldrem_n locked.
• Adjustthe miter base so thatit isparallelto the blade
see To Check Miter Base Parsltellm'n.
• Retighten the [eftfi'ont screw(N).
• Clamp the rearmiter Lockingclamps (M).
• Retightenthe two rear screws(L).
M L
M
K
MITERTABLE
SLIDES
Fig. 34
TO ADJUST THE MITER FENCE
See F_Jras 34 - 35.
II Set the miter fence(H)at 0°. Miter indicatorshouldbe
set preciselyon 0° and securedin place with adjusting
cl_¢np(J).
• Ther_arefour slideslocated underthe s_dingmiter
ta,ble. These slideslet the miter table move onthe
base. Threeslidesare mounted on eccentricscrews
that can be adjustedby looseningthe hexnutson top
ofthe mitertable.,
• Loosenthe rearhex nuts (Q)on top of slidingmiter
table for thisadjustmentprocadure.
NOTE: The front screws(R)are ontyneededto remove
excessiveplay in the slidesdue to wear from extended
use. They are not neededfor this procedure.The right
fronthex nutisa non-eocantricpivotand shouldnever
be ;oasened.
• Adjustthe rightrear eccantrJcscrew fromthe lower
side ofthe miter table so that maximum play exists
betweenthes_ideand m'ftarbase.
K
• Pushleftrear ofmiter table snugly againstmiterbase
Fig.33 as shown by the arrow(S) in figure 35 and secure,
• P_ca a fi_'nlng squarefirmlyagainstthe miterfence,
with the other,rideagainstthe blade.
• Adjust left rear screwfrom undern_th mitertable until
miter fenceend brads are squarewith eachother,
28
