Filter
Top Products
• Tightenhex nut securely.
• Adjust rightrear screwfromunderneathmitertable to
remove excessiveplay.
• Tighten hex nutsecurely.
• Recheckyoursetups carefully.Alse make surea[[
screws, hex nu_s,etc., h_vebeen tightenedsecurely.
• If slidingmitertable assemblyisstillnotsquare with
the blade, repeat the above proceduresas needed.
• Make surethat sfidss remainsquareto miter base
edo,eto preve_ =oookir=_=whichwillresultin excessive
play in miter table.
TO ADJUST QUICK STOP
See Figure38.
The quick stopis preset at thefactoryto stop the miter
fenceat sxactiy zerodegrees. However,when sliding
miter table adjustmentsare made, these adiustmentsmay
causethequickstop to need adiusting.Check qu(ck stop
withmiterscale set at zero degrees.Ifadjustmentsare
needed,proceedwith the followingsteps:
• Loosenthe eccentric screwholdingthequickstop.
• Piecethe quickstop againstthe miter fence with miter
scaleset at zero degrees.
• Adjusteccentricscrew untilit holdsquickstop securely
a_]aJnstmiter fence.
• Rstk..lhtenhe);nut, secur{ngeccentric screwand q,qck
stop.
• Check yourwork. If the quickstop isnotat zero
degrees,repeat above steps.
t
Q
Fig. 35
QUICK
STOP
Fig. 36
29