Filter
Top Products
= When the outla made, turn the saw off.Wait forthe
bladeto come to a completestop before removingthe
workplace.
• After the bladehasstopped oomplateiy, removethe
cutoffstock.
• Grasp the workplece from the lead end (theand fed
into the b{adefirst) and carefullyremove itfrom the
table.
BEVEL.RiPCUT
8LADE
ANGLED
SCALE
\
• Loosenthe lock knobon the miter gauge, set the miter
gaugeto the desiredangleand tightenlock knob.
• Turnthe powerswitch to theON position.
• Positiontheworkpiece fiaton the tablewith the edge
flushagainstthe miter gauge. Let the blade buildup to
full speed before feedingtheworkplace Intothe blade.
• Advancetheworkplaceand themiter gaugetoward
the blade. Keep the workpieceflushagainst themiter
gauge. Pushthe miter gaugeand workplacetoward
the blade. Stand slightlytothe sideof the wood as
itcontactsthe blade to reduosthechance of injury
shouldkickback occur.
II Whenthe out Is made, turnthesaw off. Wait for the
blade to come to a completestop beforeremovingthe
workplace.
• Afterthe blade hasstopped completely,remove the
cutoffstock.
COMPOUND(BEVEL)MITERCUT
PL_ RIGHTHAND
ONWORKPIECEAND
MR'ERGAUGEHERE
Fig. 46
MAKING A COMPOUND (BEVEL) MITER CUT
See Figure47.
It is recommended thatyou place the piece to be saved
on the left side of the bladeand that you make a test cut
on scrapwood firsL
_1, WARNING: Make surethe blade guardass_"nbly
isinstalledand workingpropedyto avoid sadoue
posaiblainjury.
• Removetheripfence byliftingthe lock downhandle,
• Unlock:he bevel lockinglever.
• Adjustthe bevel angleto the desiredsetting.
• Lock the bevellocking lever.
• Setthe saw blade to the correctdepth.
34