TOCHECKTHEALIGNMENTOFTHERIPFENCE
TOTHEBLADE
SeeFigure 64.
• UnpLugthe saw.
• Raisethe (ooking handleto permitthe ripfence tobe
moved.
BLADE
SCREWS
TO ADJUST THE BEVEL LOCKING LEVER
See FTgura65.
"Fhebevel lookinglevermay work looseand require
adjusting.Toadjust:
• Unplug thesaw.
• Push the leverfull leftto thefecked position.
• Remove the screwon t_e heighS_beveladjusting
handwhaeLYouwritneed the3/16 in,hex keyfor this
procedure.
• Removethe height/bevel adjustinghandwhseland
cam. Pullout the cam.
• Remove the set screwonthe bevel lockinglever.
• Remove the bevellockingleverfrom hex nut,
II Relocatebevel locking leveron the hsx nut.
• Replace set screwandtighten securely.
• Replacethe cam sothat the lobeis againstthe tab.
Make surethe cam isseated inthe lever.
• Reaseemb)sthe height/bevel adjustinghandwheelto
the shaftand cam. Checkwhether the leverisnow in
the desiredposition.Tightenscrewsecurely.
HEIGHT/BEVELADJUSTING
HANOWHEEL
SOCKET
H_DS_EW
SETSCREW
LOCKING
HANDLE Fig.64
• Placea framing squarebeside theblade and movethe
rLpfence up tothe square. Takethe dimensiononthe
ripscale.
• Move thefence back and turnthe framing square180°
to checkthe otheraide.
• If thetwo dimensionsare not the same, loosenthe two
s_'ewa on_s fence end alignit.
• Retightenthe two screws.
• Make two or three test cutson scrapwood. it thecuts
are not true,repeat the process.
NOTE: The rip fence must besecurewhen the locking
handle isengaged.The clamp screwon the rearofthe rip
fence istightened byturningclockwiseto increasetight-
nessof the rearof the ripfence.
CAM
COMPRESSION
SPRING
HANDWHEEL
ADAPTER
HEXNUT
,BEVEL
LOCKING
LEVER
Fig.65
43
