Filter
Top Products
22
ENGLISH
Machine lacks power
The saw blade is blunt and worn (possi-
bly has heat marks from overheating):
The saw blade you use is not suitable for
the material you are cutting (see chapter
15, "Technical Specifications", and
install a proper saw blade);
Saw blade warped
x Re
place the saw blade as described
in chapter 9.1.
Saw vibrates heavily
Saw blade warped
x Replace the saw blade as described
in chapter 9.1.
Saw blade incorrectly mounted:
x Remove the saw blade and then
mount it again correctly by following
the steps outlined in chapter 9.1.
Saw squeals when starting
The drive belt is loose:
x Check, tighten or, if necessary,
replace the drive belt as outlined in
chapter 9.2.
Rotating table does not move at all or
is hard to turn
Saw dust has built up under the rotating
table:
x Remove the saw dust as outlined in
chapter 9.7.
15. Technical Specifications
Voltage V120 V (1~ 60 Hz)
Current draw amp 15
Fuse protection amp 20
Protection class IP 20
Degree of protection II
Saw blade speed rpm 5200
Cutting speed fpm 13345
Saw blade diameter (outer) in. 10
Arbor bore in. 5/8
Dimensions
Machine in shipp
ing carton
length / width / height
Machine ready to work, rotating table in 90° position, c/w suction port
length / width / height
in.
in.
31 1/2 x 23 1/2 x 18 1/2
22 3/4 x 34 3/4 x 23 1/2
Maximum work piece cross section
Standard
cross cuts
width / height
Miter cuts (rotating table 45°)
width / height
Bevel cuts (track arm holder 45° left)
width / height
Compound miter cuts (rotating table 45° / track arm holder 45 ° left)
width / height
in.
in.
in.
in.
11 7/32 x 3 3/16
7 7/8 x 3 3/16
11 7/32 x 2 1/8
7 7/8 x 2 1/8
Weight
Machine in packing
Machine ready to work
lbs
lbs
57.3
44
Permissible ambient temperature for operation
Permissible temperature for transport and storage
°F
°F
32 to 104
32 to 104
Noise emission according to EN ISO 3744
Sound power level L
WA
sound pressure level at operator ear L
PA
dB (A)
dB (A)
118
104
Effective value of weighted acceleration
(Vibration at handle) ft/s
2
< 8.2
Dust collector (not included in standard delivery)
Suction port diameter
Minimum air volume flow
Minimum vacuum at suction port
Minimum air speed at suction port
in.
cfm
psi
fpm
1 1/2
323
0.107
3937