Filter
Top Products
CABLES AND CORDS
30 - 1
ETC00781(4) Series 100 e 02/2004
30. Cables and Cords
To stay in conformance with EMC requirements use our shielded data cables
(optionally available) or equivalent data cables only!
The operator has to ensure that the cable shield is connected in correct manner
(chapter 29.10):
Shield and connector's housing have to be electrically linked and the housing
screwed to the analyzer.
Analyzers with external terminal adaptors (option) do not meet the EMC
requirements if the adaptors are not installed in a shielding enclosure.
In this case the customer acts like a "manufacturer of system" and has
to confirm conformance.
The standard terminal adaptors inside BINOS® 100 F and optional terminal
adaptors for other BINOS 100 series analyzers connect the submin D connector
pins to terminals of the same denominator (submin D pin 1 is connected to
terminal 1, pin 2 to terminal 2, ...), so pin assignments given in this manual do not
change when using adaptors.
30.1 24 V DC Supply Cable
NGA-ACC-PS5 Power supply cable for connection of 100 series with UPS/BINOS
®
100 2M,
1 m, one elbow socket/ one straight plug
NGA-ACC-PS6 Power supply cable for connection of 100 series with UPS/BINOS
®
100 2M,
2 m, one elbow socket/ one straight plug
NGA-ACC-PS7 Power supply cable for connection of 100 series with 5 A / 10 A power
supply, 2 m, one side elbow socket, other side 3 single conductors
24 V DC INPUT / OUTPUT