Filter
Top Products
SAFETY SUMMARY
S - 6
ETC00781(4) Series 100 e 02/2004
VI. Analyzer specific notes for the user
The installation site for the instrument has to be dry and remain above
freezing point at all times.
The instrument must be exposed neither to direct sunlight nor to strong
sources of heat. Be sure to observe the permissible ambient temperature !
For outdoor sites, we recommend to install the instrument in a protective
cabinet. At least the instrument has to be protected against rain (e.g., shelter).
Do not interchange gas inlets and gas outlets !
All gases have to be supplied to the analyzer as conditionned gases !
If corrosive gases are inserted into the instrument, it has is to be verified that there
are no gas components which may damage the gas path components.
Ensure that all gas connections are made as labeled and are leak free !
Improper gas connections could result in explosion and death !
The unit´s exhaust may contain hydrocarbons and other toxic gases such as
carbon monoxide ! Carbon monoxide is highly toxic !
Permissible gas pressure of sample gas / test gases max. 1,500 hPa !
The exhaust gas lines have to be mounted in a declining, descending,
pressureless and frost-free and according to the valid emission legislation !
In case it is necessary to open the gas paths, close the analyzers
gas connections with PVC caps immediatly to avoid pollution of gas paths !
BINOS
®
100 F lift points are labeled ! Labels showing down side for transport !
Do not use electronics of the optional pressurization system as handle !
Use only optional delivered cables from our factory or equivalent shielded cables
to be in agreement with the CE conformity.
The customer has to prove that the shield is connected correctly (chapter 29.10).
Shield and connectors housing have to be connected conductive.
Sub. min. D plugs/sockets have to be screwed to the analyzer.
The analyzer (excepting BINOS
®
100 F) is not in agreement with the CE
conformity if optional terminal strip adapters are used In this case CE
conformity must be declared by customer as “manufacturer of system”.
ANALYZER SPECIFIC NOTES FOR USER