Filter
Top Products
F-50
TROUBLESHOOTING & REPAIR
F-50
IDEALARC SP-250
PROCEDURE
See Figure F.18 for fan motor and fan
removal components.
FIGURE F.18 - Fan Motor and Fan
Removal Components
1. Remove the Case Back screws.
2. Remove the gas solenoid using a
3/4" open end wrench.
3. Using a 5/16” wrench, remove the 5
screws holding the fan motor mount-
ing bracket to the case back.
4. Tilt the Case Back away from the
machine and remove the screws
holding the Case Back to the floor of
the machine using a 1/2" socket
wrench with extension.
5. Loosen the two screws holding the
reconnect panel in place and a slide
the reconnect panel from the frame.
6. Remove the fan blade. Note fan
blade position on motor shaft for ref-
erence for replacing fan.
a. Pry the fan blade off the motor.
b. Slide the fan blade off the motor
shaft.
FAN MOTOR AND FAN REMOVAL AND REPLACEMENT
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC