Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OPERATION
B-4 B-4
SQUARE WAVE TIG 275
• Provides excellent arc starting and stability through-
out the machines wide current range (5 to 315 Amps)
to handle the vast majority of TIG welding applica-
tions.
• Simple output current dial allows the user to preset
the peak current within the full output range of the
machine.
• Highly resistant to AC arc rectification.
• Thermostatically protected to prevent equipment
damage.
• No tungsten spitting within current range of electrode.
• Designed to make maintenance and servicing easy.
• 115 Volt Receptacle with 10 Amp Circuit Breaker.
Domestic and Canadian Models Only.
• 220 Volt European (Schuko) type Receptacle with 2
Amp Circuit Breaker. European Model Only.
• Low Voltage Trigger Circuit (18 VAC) for maximum
operator safety.
• Remote Receptacle for Amptrol or Arc Start Switch
connection.
• Gas Valve Inlet fitting conforms to Compressed Gas
Association (CGA) standards.
WELDING CAPABILITY
The Square Wave TIG 275 is rated at 275 amps, 31
volts, at 40% duty cycle on a ten minute basis for DC
TIG and AC/DC stick processes. It is capable of high-
er duty cycles at lower output currents. If the duty
cycle(s) are exceeded, the thermostatic protection will
shut off the output until the machine cools to a normal
operating temperature.
LIMITATIONS
The Square Wave TIG 275 is not recommended for AC
TIG welding when high concentrations of helium gas
are used for shielding. This causes starting and arc
rectification problems. Also the Square Wave 275 is
not recommended for arc gouging due to it's limited
output capacity. The Square Wave TIG 275 is also not
recommended for pipe thawing.