Filter
Top Products
20
menu will appear, allowing you to display data from a single engine or
show data from all engines. (If you select
FUEL RANGE (RNG) or if your
unit is configured for one engine, you will be taken back to the main
display.)
5. Select the desired engine or, to display data from all engines,
highlight Vessel and press
MENU. You will be taken back to the main
display, where the data you selected will be shown. Repeat these steps
to customize the other data position.
To customize Fuel Manager page:
1. After the Fuel Manager page has been added to the page screen
rotation, use the
UP and DOWN keys to display it on the screen.
2. Press
MENU, select CUSTOMIZE and press MENU.
3. Highlight
FUEL FLOW (FUL: F), FUEL USED (USD), FUEL RANGE (RNG), TRIP
FUEL USED (USD: TP) or SEASONAL FUEL USED (USD: SE) and press MENU. A
menu will appear, allowing you to display data from a single engine or
show data from all engines. (If you select
FUEL RANGE (RNG) or if your
unit is configured for one engine, you will be taken back to the main
display.)
4. Select the desired engine or, to display data from all engines,
highlight Vessel and press
MENU. You will be taken back to the main
display, where the data you selected will be shown.
Reset
The Reset command will reset EP-60R Fuel Flow values to default
settings.
NOTE:
After using the Reset command has been executed, you will have to
re-enter your engine-tank configuration. The Reset command will
not affect the configuration or calibration of other devices on the
network.
To use reset command:
1. Press
MENU, select SYSTEM SETUP and press MENU.
2. Highlight
BUS DEVICES, select the desired fuel flow and press MENU.
The Configuration Options menu will appear.
3. Select
RESET and press MENU. The following message will appear: Hit
Menu to Rst Values.
4. Press
MENU, then let the menus time out to return to the main
display.