Filter
Top Products
44
Alarm Status Tab
The Alarm Status tab is the second tab at the top of the NMEA 2000
Alarms page. When an alarm has been set for a device, the alarm and
its current status will be shown on the Alarm Status window.
To view Alarm Status:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
2. Select
NMEA 2000 ALARMS and press ENTER.
3. Highlight the Alarm Status tab.
4. Press
EXIT repeatedly to return to the main display.
Restore Defaults
The Restore Defaults command allows you to reset EP-60R Fuel Flow
settings to factory defaults.
NOTE:
After using the Restore Defaults command, you will have to re-
enter your engine-tank configuration. It, however, will not affect
the configuration or calibration of other devices on the network.
To use the Restore Defaults command:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
A menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired fuel flow and press
ENTER. The Device
Configuration menu will appear.
4. Highlight
ADVANCED OPTIONS and press ENTER.
5. Select
RESTORE DEFAULTS and press ENTER. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
YES and press ENTER. Press EXIT repeatedly to return to
the main display.