Filter
Top Products
32
data from a single engine or from all engines on the vessel. (If you select
FUEL RANGE or if your unit is configured for one engine, you will be taken
back to the Position menu.)
5. Select the desired engine or, to display data from all engines,
highlight Vessel and press
ENTER. You will be taken back to the
Position menu. To display data in another data box, repeat Steps 3-5.
6. Press
EXIT twice to return to the main display.
To customize Fuel Manager page:
1. After the Fuel Manager page has been added to the page screen
rotation, use the
ENTER and EXIT keys to display it on the main screen.
2. Press
MENU, use the UP and DOWN keys to select CUSTOMIZE and press
ENTER. The Position menu will appear with three options: Top Data,
Center Data and Bottom Data.
3. Highlight the desired data position and press
ENTER.
4. Select
FUEL FLOW, FUEL RANGE, FUEL USED, TRIP FUEL USED or SEASONAL FUEL
USED and press ENTER. A menu will appear, allowing you to display
data from a single engine or from all engines on the vessel. (If you select
FUEL RANGE or if your unit is configured for one engine, you will be taken
back to the Position menu.)
5. Select the desired engine or, to display data from all engines,
highlight Vessel and press
ENTER. You will be taken back to the
Position menu. To display data in another data box, repeat Steps 3-5.
6. Press
EXIT twice to return to the main display.
Reset Values
By accessing Reset Values from the Fuel Flow menu, you will be able to
reset configuration and calibration settings for a particular fuel flow.
NOTE:
After using the Reset Values command, you will have to re-enter
your engine-tank configuration. It, however, will not affect the
configuration or calibration of other devices on the network.
To reset values:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
ENTER.
2. Highlight
BUS DEVICES and press ENTER. Select the fuel flow you want
to reset and press
ENTER.
3. Choose
RESET VALUES from the fuel flow menu and press ENTER. The
following message will appear: Press Enter to Reset Device Values.
4. Press
ENTER and you will be taken back to the Bus Devices list.