Filter
Top Products
41
4. Highlight
FILL TANK and press ENTER. The following confirmation
message will appear: Are you sure you wish to Fill Tank?
NOTE:
You must use the unit’s Fill Tank command when filling your fuel
tank to keep the fuel flow updated with correct information on the
amount of fuel in the tank.
5. Select
YES and press ENTER. The following confirmation message will
appear: Do you wish to re-calibrate the device?
6. Highlight
NO and press ENTER.
7. Take your vessel out on the water and burn at least five gallons of
fuel. Be sure you run only ONE engine — the engine connected
to your fuel flow.
8. Fill up your tank again, noting how much fuel you added to the tank.
Compare that number to the Fuel Used figure displayed on your
display unit's screen.
If the amount of fuel you added to the tank and the fuel used figure are
off by more than 3 percent, we recommend the fuel flow be calibrated.
To calibrate a fuel flow:
9. Fill up your tank. Press MENU twice, select NMEA 2000 or NETWORKING
and press ENTER.
10. Highlight
FUEL MANAGEMENT and press ENTER. Highlight TANK LOCATION
and press
ENTER.
11. Select the desired tank location and press ENTER.
12. Highlight
FILL TANK and press ENTER. The following message will
appear: Are you sure you wish to Fill Tank? Select
YES and press
ENTER.
13. The following message will appear: Do you wish to re-calibrate the
device? Select
YES and press ENTER.
14. Repeat these steps for each EP-60R Fuel Flow you want to
calibrate.
Engine Operations
The lower half of the Fuel Management menu covers Engine
Operations, which include: Engine Select, Reset Calibration, Reset Trip
and Reset Seasonal.
Engine Select
Engine Select allows you to choose the desired engine when resetting
calibration, resetting trip fuel and resetting seasonal fuel.