Filter
Top Products
35
Setting Engine-Tank Configuration:
1. Press MENU twice, highlight NMEA 2000 or NETWORKING and press
ENTER.
2. The NMEA 2000 menu will appear with five options: Bus Setup,
Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and
Backlight Synchronization. Choose
BUS SETUP and press ENTER.
3. Select
ENGINE & TANK CONFIG and press ENTER, which will open the
Engine & Tank Configuration menu with the following configuration
options: 1 Engine/1 Tank, 1 Engine/2 Tanks, 2 Engines/1 Tank, 2
Engines/2 Tanks, 3 Engines/1 Tank, 3 Engine/3 Tanks and
Unconfigured Bus.
4. Choose the configuration that matches the number of engines and
tanks on your vessel and press
ENTER.
5. Highlight
TANK SELECT and press ENTER, which will open the Tank
Select menu.
6. Select the tank you want to set up and press
ENTER. Highlight the
Tank Size dialog box and press
ENTER.
1 Engine/1Tank highlighted on Engine and Tank Configuration
menu (left). Starboard highlighted on Tank Select menu (center).
Tank Size set to 40 gallons (right).
7. Input the capacity (gallons) of the tank you chose from the Tank
Select menu and press
ENTER.
8. Repeat Steps 5-7 for each remaining tank.
9. When all tanks have been configured, press the
SET CONFIGURATION
button. The following confirmation message will appear: Are you sure
you wish to change the bus configuration? Choose
YES and press ENTER,
Press
EXIT to return to the main display.
NMEA 2000 Devices List
Devices connected to your NMEA 2000 network will be listed on the
NMEA 2000 Devices list, located at the top of the Bus Configuration