Filter
Top Products
23
1. Press
MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
ENTER.
2. Highlight
BUS DEVICES and press ENTER. The Bus Devices list will
appear.
Bus Devices highlighted in the System Setup menu (left). Searching
Bus Devices window (center) with Bus Devices list (right).
3. Select UNCFG F FLOW and press ENTER. The following message will
appear: Press Enter to Configure Fuel Flow Snsr.
4. Press
ENTER. If your unit is configured for more than one tank, the
Select Engine menu will appear. (If your unit is set to a single-tank
configuration, the Select Engine menu will not appear. The fuel flow
will automatically be given the configuration name Eng FFlow.)
5. Select the desired engine and press
ENTER. You will be directed to
the Bus Devices list. Press
EXIT repeatedly to return to the main
display.
To unconfigure a fuel flow:
You will use the Unset Engine command to unconfigure a fuel flow.
To unset engine:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
ENTER.
2. Highlight
BUS DEVICES and press ENTER to open the Bus Devices list.
3. Select the desired fuel flow and press
ENTER. The Fuel Flow menu
will appear. Select
UNSET ENGINE and press ENTER. The following
message will appear: Press Enter to UnConfig Device Name
.
4. Press ENTER and you will be directed back to the Bus Devices list,
where the fuel flow you unconfigured will be shown as UnCfg F Flow.
To reconfigure a fuel flow:
You will use the Change Engine command to reconfigure a Fuel Flow.
Change Engine, however, will only appear on the LMF-400 menu if a
multiple engine setting was chosen during Boat Setup. If all the fuel
flows on your vessel are configured, you will have to unconfigure a fuel