Filter
Top Products
38
5. Highlight the device and press
ENTER. The Device Configuration
menu will open. The device name will be reset to its default setting.
Press
EXIT repeatedly to return to the main display.
Location
The Location menu allows you to select a configuration name that
matches the location of the engine connected to your fuel flow sensor.
To change fuel flow location:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight
BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the fuel flow you want to configure and press
ENTER. The
Device Configuration menu will appear.
4. Select
LOCATION and press ENTER, which will open the Location menu.
NOTE:
If you want to unconfigure your fuel flow, select
UNKNOWN from the
Location menu.
5. Highlight the desired location and press
ENTER. The following
message will appear: Are you sure you wish to change this device's
configuration?
6. Select
YES and press ENTER. Press EXIT repeatedly to get back to the
main display.
Unconfiguring an EP-60R Fuel Flow
You can unconfigure a fuel flow by manually resetting its Location to
default settings (Unknown) via the Location menu or you can use the
Restore Defaults command.
To reset the fuel flow's device name, refer to the previous segment
covering Device Name. The Device Name also may be reset by using
the Restore Defaults command.
NOTE:
If you execute the Restore Defaults command, you will have to re-
enter your engine-tank configuration settings. The Restore
Defaults command is covered at the end of this section.