Filter
Top Products
Hex bolt M6x45
Flat washer 6
P 17/ 30
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -9. Assembling Feet Section
Fig. 44 Fig. 45
1) For smooth folding action of the Feet section, follow the steps described below to assemble Support bracket to
Square pipes precisely at an angle of 90 degrees:
i) Put Support bracket on Square pipe 32-510, while keeping about 238 mm distance from the top of Support bracket
to the top end of Square pipe. You don't need to tighten hex bolt M6x45 securely in this step.
Then while applying angle ruler to Square pipe and Support bracket, adjust the angle to 90 degrees. (Fig. 44)
ii) While keeping the 90 degrees obtained in the previous step, tighten the bolt securely to fasten Support bracket to
Square pipe 32-510.
iii) Fasten Support bracket to Square pipe 32-475 as the same way you have done in the steps i) and ii).
The distance between Square pipe 32-510 and Square pipe 32-475 will be about 529mm if Support bracket is
assembled correct to the two pipes. (Fig. 45)
LEFT FEET SECTION
Hex bolt M6x45
Flat washer 6
Flat washer 8
Hex nut M6
Flat washer 8
Hex nut M6
Framing square
Framing square
Square pipe
32-510
Square pipe
32-475
Support bracket
approx.
283mm
approx.
529mm
approx. 283mm
Square pipe
32-510
2) See Fig. 46. Mount Bracket on Square pipe 32-510 from the Support bracket installation side.
Put Pin 8 (long) through Flat washer 8, elliptic holes of Bracket and the first holes from the top of Square pipe 32-510.
And secure the Pin 8 with another Flat washer 8 and Stop ring E-6. Then assemble another Pin 8 (long) in the second
hole from the top of the Square pipe as illustrated below.
3) See Fig. 47. Assemble Bracket to the first hole from the top of Square pipe 32-475 as the same way you have done
in the step 2). Then assemble Pin 8 (long) in the second hole from the top, and Pin 8 (short) in the third hole from
the top as illustrated below.
Bracket
Bracket
Support bracket
Fig. 46 Fig. 47
Installing Bracket on Square pipe 32-510 Installing Bracket on Square pipe 32-475
Support bracket
Pin 8 (long) Pin 8 (short)Flat washer 8 Sleeve 8 Stop ring E-6