Filter
Top Products
P 25/ 30
Wiring diagram
[2] Wiring in Handle
All European Countries Except UK-110V
Switch
Line filter
Strain relief
10 - 20mm
10 - 20mm
Connecting cord
from Switch box
L-shaped ribInside wall A
Lead wires from
Controller and Field
Bottom of Handle
Handle cover side
Brake switch
Bottom of Handle
Handle cover side
Connect lead wires to Brake switch as illustrated below.
How to Connect lead wires to Brake switch
Correct Wrong
Brake switch
Band
Noise
suppressor
Be careful not to
route lead wires
over Strain relief.
Put Line filter between Strain relief and Band.
Install Connecting cord and Band on Handle so that;
*the distance between the end of Connecting cord and the inside wall A is 10 - 20mm
*the distance between the end of Connecting cord and Band is 10 - 20mm.
Route the three lead wires to Switch and
the two lead wires to Brake switch between
the L-shaped rib and the inside wall A.
(See page 29 for UK-110V.)