Filter
Top Products
P 7 / 30
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Motor Housing
Fig. 12
Fig. 13
DISASSEMBLING
Fig. 11
Motor housing
1) Remove Brush holder caps and Carbon brushes from Motor housing.
2) Remove four M6x60 Pan head screws using No.3 Phillips screwdriver. (Fig. 11)
Note: Motor housing can not be separated from Blade case in this step because Handle is interfered by Lock lever.
3) Turn Motor housing until handle is released from Lock lever. Then separate Motor housing from Blade case
by pulling off. (Fig. 12) Now Armature can be replaced.
Note: Pull off Motor housing carefully so as to prevent Compression spring 9 of the shaft lock mechanism from
popping out of place.
Pan head screw M6x60
Lock leverHandle
4) When replacing Field, separate Motor housing first as described above.
5) Then remove Rear cover from Motor housing. Remove Handle cover complete from handle, and disconnect lead
wires from Field. Now Motor housing can be separated from Handle. (Fig. 13)
6) After removing Baffle plate, remove Field by tapping the edge of Motor housing with plastic hammer. (Fig. 13)
Rear cover
Baffle plate
Motor housing
Field
Handle cover
complete
Handle
Blade case
Motor housing
Disconnect
the lead wires.
ASSEMBLING
Do the reverse of the disassembling steps.