Filter
Top Products
P 20/ 30
Repair
[4] ADJUSTMENT
[4] -1. Adjusting Bevel Angle
Fig. 52 Fig. 53
Fig. 54 Fig. 55
1) Lock the saw head unit in the full down position, and loosen Lever 100. Then rotate the 90 degree adjusting screw
two or three turns counterclockwise using Hex wrench 3, and tilt the blade to the right. (Fig. 52)
2) Put 90 degree set square (No.1R208) on the top surface of Turn table and beside the blade. Turn the 0 degree
adjusting screw carefully clockwise until No.1R208 closely contacts the blade without gap between their surfaces
and between the surfaces of No.208 and Turn table. Then tighten Lever 100. (Fig. 53)
3) After performing this adjustment, make sure that the pointer of Indication plate is indicating 0 degree on Bevel scale.
If not, loosen the screw that fastens Indication plate and adjust the pointer to 0 degree.
[Bottom of Table viewed from the Lever 100 installation side] [Table and Blade viewed from
the Lever 100 installation side]
[Bottom of Table viewed from the Lever 100 installation side]
[Table and Blade viewed from
the Lever 100 installation side]
0 degree adjusting screw 45 degree adjusting screw
0 degree adjusting screw 45 degree adjusting screw
No.1R207
Lever 100
Saw head unit
Important: Before performing 45 degree bevel angle adjustment, be sure to do 0 degree bevel angle adjustment.
1) Tilt the saw head unit fully to the right. (Fig. 54)
2) Put 45 degree set square (No.1R207) on the top surface of Turn table and beside the blade. Turn the 45 degree
adjusting screw carefully clockwise until No.1R207 closely contacts the blade without gap between their surfaces
and between the surfaces of No.207 and Turn table. Then tighten Lever 100. (Fig. 55)
3) After performing this adjustment, make sure that the pointer of Indication plate is indicating 45 degrees on Bevel
scale. If not, loosen the screw that fastens Indication plate and adjust the pointer to 45 degrees.
0 Degree Bevel
45 Degree Bevel
[right][left]
No.1R208
Saw blade
Turn table
[right][left]
[right][left]
[right][left]
Saw blade
Turn table