Filter
Top Products
P 3 / 30
Repair
[1] NECESSARY REPAIRING TOOLS
CAUTION: Remove the saw blade from the machine for safety before repair/ maintenance !
Code No.
1R003 Retaining ring S Pliers ST-2N Removing Retaining ring from Safety cover
1R207 45 degree Set square Setting the miter/bevel angle of saw blade to 45 degrees
1R208 90 degree Set square Setting the miter/bevel angle of saw blade to 90 degrees
1R269 Bearing extractor Removing Ball bearings
1R288 Screwdriver magnetizer Removing Steel balls, etc.
1R230 1/4" Hex shank bit for M6 Disassembling Table
1R231 1/4" Hex shank bit for M8 Disassembling Frame
1R291 Retaining ring S and R pliers Removing Retaining ring S-15 from Spindle
1R340 Wrench for bearing retainer Removing/tightening Bearing retainer 25-36
Description
Square
No.3 Philips driver bit
Removing/tightening of M6x60 Pan head screws that secure
Motor housing to Blade case.
Assembling the legs of table
Use for
[2] LUBRICATION
Apply Makita grease N. No.1 to the following portions designated with the black triangle to protect
parts and product from unusual abrasion. See Fig. 1.
[2] -1. Saw Head Section
121
121
61
64
91
85
85
50
50 Hex bolt M10
Knob 40
Steel ball 6
The surface that contacts Arm complete
The threaded portion
Whole surface62
Sleeve 6 The surface that contacts Connecting rod64
Sleeve 10 The surface that contacts Adjust nut
Flat washer 10 The surface that contacts Connecting rod
71
Sub arm
Blade case
The gear room (Put approx. 7g.)
Two surfaces that contact Arm complete
Three surfaces that contacts Arm complete91
Connecting rod
Arm complete
Item No. Description Portion to lubricate
Adjust nut
Sleeve 13
61
71
62
Fig. 1