Filter
Top Products
5 - 4
5 Dedicated Options
MITSUBISHI CNC
5-1-1 Battery option
This battery option may be required to establish absolute position system. Refer to "Servo option" and use the
following battery option depending on the servo system.
Type MR-J3BAT MDS-BTBOX-36
Installation type Drive unit with battery holder type
Unit and battery integration
type
Hazard class Not applicable Not applicable
Number of connectable axes 1 axis Up to 8 axes
Battery change Possible Possible
Appearance
(1)
(2)
1. On January 1, 2003, new United Nations requirements, "United Nations Dangerous Goods
Regulations Article 12", became effective regarding the transportation of lithium batteries. The
lithium batteries are classified as hazardous materials (Class 9) depending on the unit. (Refer to
Appendix 2.)
2. The lithium battery must be transported according to the rules set forth by the International Civil
Aviation Organization (ICAO), International Air Transportation Association (IATA), International
Maritime Organization (IMO), and United States Department of Transportation (DOT), etc. The
packaging methods, correct transportation methods, and special regulations are specified
according to the quantity of lithium alloys. The battery unit exported from Mitsubishi is packaged in
a container (UN approved part) satisfying the standards set forth in this UN Advisory.
3. To protect the absolute value, do not shut off the servo drive unit control power supply if the battery
voltage becomes low (warning 9F).
4. Contact the Service Center when replacing the battery.
5. The battery life (backup time) is greatly affected by the working ambient temperature. The above
data is the theoretical value for when the battery is used 8 hours a day/240 days a year at an
ambient temperature of 25°C. Generally, if the ambient temperature increases, the backup time
and useful life will both decrease.
CAUTION